The cage arms are formed from six tungsten carbide coated bow springs, with additional coil springs built into the folding mechanism which are capable of supporting the weight of the tool in a horizontal well into and pulling out of hole.
OPERATING PRINCIPLE
The Flowmeter may be closed down to tool diameter while running or pulling out of hole, and opens automatically when it leaves the tubing to enter the casing. Should a restriction be encountered during logging, the flowmeter will close and fold the spinner until the restriction is passed, thus avoiding damage to the blades. The spinner runs on precision bearings. Rotation is sensed by zero drag Hall effect detectors allowing the measurement of very low flow rates. The normal output is 10 pulses per revolution with directional information.
APPLICATIONS
Horizontal and Highly Deviated Wells Full Bore Production Profiling Protection from Downhole Gas Lift Mandrels and Intrusions Logging with Coiled Tubing Full Bore Injection Profiling Low Flow Rates Detecting Leaks and INTERFACING & TOOL COMBINATIONS Interchangeable Mechanical Sections to match Casing Simultaneous Operation with other PL Tools Sondex Compatible and interchangeable. OPTIONS Casing Diameters: 4 1/2”, 5”, 5 1/2”, 7” & 9 5/8 Locking Spinner for High-Rate Injection Wells (standard for 9 5/8”tools). Solid impeller shafts for very high flowrate wells
SPECIFICATION
Telemetry XTU or UMT
Pressure(max) 105MPa(15000PSI)
Temperature(max) 177°C(350°F)
Voltage(nominal) 18VDC
Current <16ma
Casing Diameter 4 1⁄2 “ – 9 5⁄8 “
Length(make-up) 895mm
Measure Point 349mm from bottom of tool
Diameter 43mm(1 11⁄16 “) or 38mm(1 1⁄2 “)
Weight 4.5kg(7”casing 43mm)
Material Corrosion Resistance
Throughout Threshold approx. 1.7ft/min (100bpd in 7″ casing)
Max. Fluid Velocity 500 ft/min (28250 bpd in 7″ casing
End Thread(top) 13/16″ 12 UN2A
GO End connector(top) 4mm single banana connector
Reviews
There are no reviews yet.